dash/doc/reduce-traffic.md

Reduce Traffic
==============

Some node operators need to deal with bandwidth caps imposed by their ISPs.

By default, Dash Core allows up to 125 connections to different peers, 10 of
which are outbound. You can therefore, have at most 115 inbound connections.
Of the 10 outbound peers, there can be 8 full-relay connections and 2
block-relay-only ones.

The default settings can result in relatively significant traffic consumption.

Ways to reduce traffic:

## 1. Use `-maxuploadtarget=<MiB per day>`

A major component of the traffic is caused by serving historic blocks to other nodes
during the initial blocks download phase (syncing up a new node).
This option can be specified in MiB per day and is turned off by default.
This is *not* a hard limit; only a threshold to minimize the outbound
traffic. When the limit is about to be reached, the uploaded data is cut by no
longer serving historic blocks (blocks older than one week).
Keep in mind that new nodes require other nodes that are willing to serve
historic blocks.

Whitelisted peers will never be disconnected, although their traffic counts for
calculating the target.

## 2. Disable "listening" (`-listen=0`)

Disabling listening will result in fewer nodes connected (remember the maximum of 10
outbound peers). Fewer nodes will result in less traffic usage as you are relaying
blocks and transactions to fewer nodes.

## 3. Reduce maximum connections (`-maxconnections=<num>`)

Reducing the maximum connected nodes to a minimum could be desirable if traffic
limits are tiny. Keep in mind that dash's trustless model works best if you are
connected to a handful of nodes.

## 4. Turn off transaction relay (`-blocksonly`)

Forwarding transactions to peers increases the P2P traffic. To only sync blocks
with other peers, you can disable transaction relay.

Be reminded of the effects of this setting.

- Fee estimation will no longer work.
- It sets the flag "-walletbroadcast" to be "0", only if it is currently unset.
  Doing so disables the automatic broadcasting of transactions from wallet. Not
  relaying other's transactions could hurt your privacy if used while a wallet
  is loaded or if you use the node to broadcast transactions.
- If a peer is whitelisted and "-whitelistforcerelay" is set to "1" (which will
  also set "whitelistrelay" to "1"), we will still receive and relay their transactions.
- It makes block propagation slower because compact block relay can only be
  used when transaction relay is enabled.