* masternode: Replace sync states INITIAL and WAITING with BLOCKCHAIN
* masternode: Peer dependent "assume tip" timeout
I would say its enough to only wait 1 tick if we have more than 3
peers before we move over to governance sync.
* masternode: Notify the UI instantly if switched to governance sync
Without this it takes one iteration more for the UI to receive the
update.
* masternode: Notify the UI about CMasternodeSync::Reset calls
* masternode: Don't instantly reset the sync process
Give it MASTERNODE_SYNC_RESET_SECONDS (600) seconds time after the last
UpdateBlockTip call.
* rpc: Don't switch to next asset in "mnsync reset"
* rpc: Force the reset in "mnsync reset"
* net: Make sure the sync gets a reset if required after network changes
This will reset the sync process if its outdated in the following cases:
- If the connections dropped to zero
- If the connections went from zero to one
- If the network has been enabled or disabled
* Apply suggestions from code review
Co-authored-by: UdjinM6 <UdjinM6@users.noreply.github.com>
* net: Only open masternode connections if the blockchain is synced
In general it doesn't make sense to connect to masternodes before due to
MNAUTH requires blockchain sync. This could lead to failing quorum
connections/failing masternode
probing.. if a just restarted node/a out of sync node
would hit a dkg block.. Then they would not try to open those
llmq/probing connections for the next 60s (nLLMQConnectionRetryTimeout).
Thats basically what happens in tests right now and they fail without
this commit.
* test: Make sure nodes are synced when they get restored after isolation
Their sync might be out of date otherwise due to bigger mocktime bumps
Co-authored-by: UdjinM6 <UdjinM6@users.noreply.github.com>
Instead of using the initial value. This removes the need for manually
passing of -mocktime when restarting nodes.
It also fixes a few flaky test cases where nodes are getting restarted.
And really only check inbound connections for recent probes. Also bump
mocktime by an hour in llmq-simplepose.py.
This fixes flakiness of llmq-simplepose.py.
* Rename LLMQ_5_60 to LLMQ_TEST
* Introduce -llmqtestparams which allows to modify LLMQ_TEST on regtest
Also add support in DashTestFramework
* Use parameters size=3, threshold=2 as default for LLMQ_TEST
And fall back to the old parameters where necessary
* Wait for all contributions, even when one member is lying
Otherwise we might end up continuing too fast, which would fail the DKG.
* Update src/chainparams.cpp
Co-Authored-By: UdjinM6 <UdjinM6@users.noreply.github.com>
Co-authored-by: UdjinM6 <UdjinM6@users.noreply.github.com>
* Refactor `HandleFullyConfirmedBlock()`
* Pass `pindexMined` into `AddNonLockedTx()`
* Unify time import in Dash specific tests
* Refactor UpdateSpork and SetPrivKey
